How to replace glass from casement aluminum window

Time:2024-06-25 Browse:588

When you see this article, your window glass may be accidentally destroyed, or you may want to change it for a new glass. Whether your old glass is in an casement aluminum window frame, an aluminum sliding window frame or a aluminum misquito extrusion, the replacement method is basically used. As you read this article, you should know how to replace the old glass on your casement aluminum window profiles.

Step 1

Remove the old glass. The old glass is held in place by the aluminium window frame. After the large piece of glass is taken out, the broken glass cannot be left. The broken glass in your aluminum casement window profiles should be removed because any glass fragments or dust It will affect the correct placement of the new window glass in the aluminum window profile. It is important to note that safety gloves must be worn when removing broken glass to avoid scratching the glass. You also need to clean the old silicone with a knife, so it is best to wear protective glasses as well.

Step 2

Measure the size of the casement windows extrusion opening in which the glass is located. Take a few more measurements, because it's related to buying new window glass, only the right size to install the glass into the casement window profiles, so that the window is more sealed.

Step 3

You need to test the fit by placing the new glass in a aluminium casement windows frame. When you put the window in, make sure it is in the right place. Then, put at least one screw on the top to fix the approximate position. You can go around and look around to evaluate the suitability of the glass and your casement aluminum window profiles, then adjust it until the glass window is level.

Step 4

You can use transparent silicone beads to adhere the glass to you aluminum window extrusion. Because there are inevitable gaps between the glass and the casement window frame, silicone can fill these gaps and prevent the glass from squeaking during windy weather, especially in winter.

Step 5

Measure and cut the appropriate size vinyl strip so that it is outside the window. It is best to install the glass before, because this is also one of the preparations for the official installation.

Step 6

Place the new glass plate on the surface. You need to make sure that the surface is smaller than the glass plate so that it hangs on both sides. Replace the glass beads on either side of the glass plate hanging on the edge and place half of the aluminum window profiles on the pane. Gently tap with a rubber mallet until the glass is fastened or secured in the frame. Repeat this step with the other half of the frame and secure with the screws on the two corners.

Step 7

The next step is to simply nail or tighten the screws around the new window.

The above is about replacing the glass on the aluminum casement window frame. In fact, it is easy to grow. The most important thing is to do the protection work. Don't hurt your hand because of changing the glass. If you still have questions that you don't understand, you can always consult us through the official website.